Dezhou Huarui Machinery Equipment Co., Ltd. is a professional manufacturer of woven bag packaging equipment, with an annual output of more than 10,000 woven bag processing equipment, and its products are sold to more than 20 countries and regions.
The correct use of the woven bag cutting machine:
1. It is best to install a 500V power supply regulator when using the woven bag cutting machine. The cutting machine parts and connecting rods need to be lubricated. Lubricate the Spring grooves at the left and right ends of the cutter before use, and lift the cutter up and down several times by hand. The purpose is to make the cutting tool smooth.
2. Always check whether the travel switch and cam in the cutting machine are normal, whether the cam Screw is loose; check whether the connecting rod of the transmission is rusted or not smooth; whether the spring before cutting is too tight and there is no refueling. In order to avoid the problem that the cutting knife can not be lifted.
3. When using the woven bag slitting machine cutting machine, pay attention to ensure the balance between the cutting machine and the printing machine. The printing machine should be 10 cm high to reach the balance. The cutting knife is often worn and the cutting machine can be used very well.
4. The cutting tape can be used to remove the iron piece attached to the machine, and the tape is covered with a paper sleeve. When the cutting machine is placed, it is close to the paper exit position of the printing machine, and then the paper is jammed at the knife edge. Squeeze the tape.
Main: woven bag single sewing machine, double sewing machine, woven bag sewing machine, woven bag folding machine, woven bag slitting machine, non-woven printing machine, single sewing machine, woven bag cutting machine, sewing machine , woven bag printing machine, hot melt adhesive sealing machine, crusher, bag turning machine, whole roll printing and winding unit, automatic full-volume printing cutting unit, whole roll bag turning machine, automatic bag cutting machine, packing machine, gathering Ethylene blown film machine.
The company has won wide acclaim from users for its high-quality products and excellent services. It takes science and technology as the guide, survives on quality, competes for market with credit, and achieves long-term development. (http://)
Recoil Springs,Steel Spring For Slap Band,Plastic Torsion Springs,Flat Wire Recoil Spring
Professional Recoil Springs manufacturer is located in China, including Steel Spring For Slap Band,Plastic Torsion Springs,Flat Wire Recoil Spring, etc.
We are factory, we had made these products 15 years, we can give you good serve and quality. Hope to business with you!
Recoil Springs,Steel Spring For Slap Band,Plastic Torsion Springs,Flat Wire Recoil Spring
Shenzhen Lanejoy Technology Co.,LTD , https://www.wire-spring.com