Today, for the decoration of bathrooms and bathrooms, how to reflect its comfort and safety has become a focus of decoration. When interviewed by reporters in the home improvement industry, the reporter learned that there are many details involved in the decoration of the bathroom. If not handled properly, it will not only directly affect the quality of future home life, but will also affect the mood. Bathroom decoration should pay attention to the following points:
→Related reading: bathroom decoration highlights
First, the threshold
The threshold is a barrier that prevents water from overflowing the bathroom. Its design and construction points are:
1) The upper plane of the sill is to be tilted towards the inside of the bathroom so that the water droplets can slide smoothly into the bathroom;
2) The threshold should be the same as the width of the door frame, and the thickness of the door frame should be the same as the thickness of the wall so that there will be no large access when laying the floor tiles, and the chance of creating a breach will be relatively reduced.
Second, the ground waterproof
There are many kinds of waterproof material, and the most popular one is water repellent. When laying a waterproof layer, it should be spread to about 20 cm above the foot of the wall. It must not be lower than the height of the lintel. When there is a reserved pipe on the floor, the waterproof layer needs to wrap the reserved pipe. After the waterproofing of the floor is done and dried, it must be immediately primed with cement mortar or protective measures to prevent damage to the waterproof layer.
Third, the laying of floor tiles
There are three essentials for laying floor tiles:
1) There must be about 1 percent of the discharge slope and the slope is towards the floor drain;
2) The seams of the tiles must be the same in thickness, and must be aligned with the seams of the tiles;
3) When the front wall of the bathtub is tiled with tiles, the tiles are best affixed to the bottom of the wall before they are attached to the wall to avoid breakage.
Fourth, washing face
The surface of the washboard countertop should be selected to be “all-in-one†(ie, the surface material of the countertop is consistent with the internal material composition and color), and a countertop with only one surface of the plastic shell cannot be selected because only the surface of the surface of the plastic shell can be repaired once it is damaged. (To test whether the countertop is "fullbody", you can use the light to illuminate from the back of the room. Light-transmissible is the "full-body" countertop). In addition, joints must be applied to the joints between the tabletop and the washbasin to prevent the water from oozing from the joints.
Fifth, the toilet
Generally, when installing a toilet, it is customary to use cement mortar to fill the toilet to fix the toilet. In fact, this method is wrong. After this method is used to fix the toilet, the toilet cannot be disassembled again. If the pipeline is seriously blocked, only knock it off. Toilet one way.
Sixth, exhaust fan
When people build houses, they usually pay less attention to bathroom ventilation equipment. Most of them only install an exhaust fan. The bad gas in the bathroom cannot be discharged outside and still just circulates in the bathroom.
Bathroom Bathroom Toilet Interior Decoration Cement Home Improvement Floor Tiles Bathroom Tiles Bathroom Doors Bathrooms Washbasins Bathrooms Waterproof Materials Bathroom Designs Bathrooms Waterproof Bathroom Flooring Tiles Flooring Tiles
Stainless Steel Safety Washers,Thickened Safety washers,DIN Safety Lock Washers,Safety Washer
Ningbo Yinzhou Zhenhua Stamping Co., Ltd. , https://www.fastenersstamping.com