Pneumatic tools are generally small, the advantage is that it is easy to use, not to be worn out, and more importantly to save money. The service life of pneumatic tools is very long, but if you use it and the maintenance method is not correct, you will find that your pneumatic tools often have one or the other problems. Many people complained about this complaint, but it is very strange that few people complain that even if they use it badly, they should learn the knowledge of pneumatic tools properly in order not to complain about pneumatic tools.
Gas supply for pneumatic tools: Use a clean, dry air supply tool of 90 PSI (6.2 Bar). Excessive air pressure will quickly reduce the life of the tool. Connect the tool to the appropriate size parts, conduits, and hoses as indicated on the tool diagram. If an air pressure regulator is used, set the air pressure to an output pressure of 0.62 MPA.
The pneumatic tool uses specific steps to connect the pneumatic tool to the air line. Set the air pressure. The air production unit must be equipped with an air lubricating oil device. If the air lubricating oil unit is unqualified or not, the following daily maintenance should be performed on the tool: after 3 to 4 hours of continuous operation, separate the tool from the air source and drop from the tool inlet. Enter 7-8 drops of high-purity light oil with low viscosity, then connect the air pipe, open the air source, and blow the oil into the cylinder. For conditional users and full working load, it is recommended to install a small oiler at the air inlet joint. Usually, the air compressor and the oil-water separator need to be regularly drained and decontaminated for 30-40 days to ensure that the air entering the tool is clean and dry.
Advantages of pneumatic tools: easy to obtain gas, low working pressure, used air can be discharged on site, no need to recycle pipeline; small viscosity of gas, small loss of flow resistance, easy to concentrate gas supply and long distance transportation; pneumatic actuator High speed of movement; pneumatic system has strong adaptability to the environment, can work reliably in a wide temperature range, wet and dusty environment, slightly leaks will not pollute the environment, no fire and explosion hazard, safe to use; simple structure, maintenance Convenient, low cost; long life of pneumatic components; pneumatic components with smaller output than hydraulic, faster movement, adaptability, can work in the harsh environment of easy, explosive, heavy, humid, impact, do not pollute the environment , long working life, simple structure, easy maintenance and low price.
The components of the pneumatic tool series: air pressure generating device _ air compressor; pneumatic actuator; pneumatic control element _ components used to control the pressure, flow and flow of the working medium to enable the actuator to complete the required motion laws, such as pressure, flow and Directional control valve and various logic components; sensing element and conversion element: qigong sensing element that detects controlled parameters and becomes a pneumatic signal, and components that convert signals such as gas signals and electro-hydraulics; pneumatic accessories _ Including gas source purification, component lubrication, component connection and noise reduction components.
Industrial Electric Winch For Truck,Electric Winch For Tow Truck,Electric Winch For Truck,Electric Industrial Winch
JINHUA RUNYE TECH. CO.,LTD , https://www.cnirunwinch.com