Pump installation and use precautions

Pump installation and use precautions Pump installation requirements: 1, the installation height should be less than allowed to suction on the vacuum height minus the loss of water in the pipeline. Under normal conditions, the installation height of 10.3- (NPSH) r-0.5-hw, in order to have suction pipe hydraulic loss: 2, the pump outlet flange should be installed on the pressure gauge, in order to observe and control the pump operating conditions : The pipe weight shall not be borne by the pump: 3, the pump should be installed in a ventilated place, outdoor installation should be added protective cover to avoid sun exposure and rain: Installation: 1, before installation, should check whether it is in the process of deformation Or damage, fasteners are loose or off; 2, the installation configuration inlet and outlet pipes: pipe installation should be as much as possible to reduce the pipeline fluid resistance principle. After the inlet pipe should be added filter to prevent hard impurities or hard solids into the pump cavity damage seal or water leaves, leading to water leakage or abnormal: inlet pipe should be added check valve to facilitate Water; 3, wiring: the nameplate must be correct wiring, wiring, the terminal must be solid, not allowed to loose, otherwise, will result in poor contact led to lack phase burning machine. The wiring must be used overload protection device, and according to the motor nameplate current requirements to adjust the size of the protection device settings; 4, press the turn method: vertical pump; 5, suction water level higher than the pump: single pump And double pump in series or in parallel; 6, the suction level is lower than the pump: such as pool pumping water; 7, lying pump directly take over the installation. Start: 1, the pump should be opened before starting the inlet valve and pump exhaust valve plug, close the outlet gate valve. Pump cavity filled with water, so that the pump can start normally: 2, jog motor, from the motor side, check the steering direction is consistent with the arrow. Operation: 1, After the pump is started to gradually open the outlet gate valve, adjusted to the desired operating point; 2, the pump is running, the operating conditions of traffic flow is not more than the performance of the parameters given in the flow table points appropriate , While the motor running current shall not exceed the rated current; 3, shutdown sequence: close the outlet pipe gate valve - motor - pressure gauge. Maintenance: 1, should always check the pump is running smoothly. The mechanical seal wear and leakage, timely replacement of seals to prevent pressure water into the motor; 2, always check the motor housing temperature changes, the maximum temperature should not exceed 85 degrees Celsius, found that the temperature is too high, should immediately stop checking; 3, the pump for a long time off, should drain net water, remove rust scale, coated with anti-rust grease for the next re-use.

Underwater Lighting

The LED underwater light is a light that is placed under the water. The appearance is small and exquisite, and the appearance is elegant. As an underwater lighting fixture, LED underwater light is widely used in various sightseeing places such as square parks. It is the perfect choice for fountains, theme parks, exhibitions, commercial and art lighting.Most of the materials are made of stainless steel and glass. The types of stainless steel are 201, 304, 316, etc.This lamp is designed with fully tempered safety glass, wide light radiation surface, strong transparency.The interior of the luminaire is highly waterproof and has a protection rating of IP68 or higher .All adopt imported high-power LED as light source, which has obvious advantages such as long life, low power consumption, pure color and no pollution. With the DMX512 control system, it can achieve a variety of color changes.If you want to know more, please contact us.

Underwater Lights,Submersible LED Lights,Underwater Boat Lights,Underwater Fishing Lights

JIANGMEN LEDERLIGHT LIGHTING Co.,LTD , https://www.ledsteplight.com