The automatic door daily inspection is first. When the inspection personnel walks toward the automatic door at a normal speed, the automatic door should be automatically opened, and there is no strange sound, and the opening operation should be smooth and there is no collision.
Second, when the inspector slowly passes the automatic door at a speed of 0.2 meters per second, the automatic door should remain open.
Third, after the detector leaves the sensor detection zone of the automatic door, the automatic door is automatically closed after a delay of 1 second to 10 seconds, and the delay time can be set by the automatic door switch parameter.
Fourth, when the inspector normally passes the walking route of the automatic door, it is necessary to adjust the daily walking route to the person facing the automatic door, instead of going to the automatic door at a certain angle.
Fifth, the sensing width of the automatic door sensor should be greater than the width of the door fully open.
Sixth, if the automatic door is equipped with an auxiliary safety light sensor (infrared radiation protection device), when the automatic door leaf is opened, the person stands still, and the auxiliary safety light sensor is blocked by hand, and the door should remain open. Within a few seconds after the hand leaves, the door should be closed again.
When the automatic door fails, you should promptly ask the professional automatic door maintenance personnel to come over and repair, in case the fault is expanded.
Http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn
Wall Washer Light,Wall Washer Led Light,Led Wall Washer Outdoor Light,Wall Wash Light Fixture
EV LIGHT Guangzhou Co., Ltd , https://www.evlightpro.com