[China Aluminum Network] The maintenance of mechanical equipment in industrial production is an important part that cannot be ignored. In order to increase work efficiency, to ensure the safety of workers during production, and to extend the service life of machinery and equipment, these can be achieved by maintaining mechanical equipment.
Today, we will talk about the daily maintenance of aluminum melting furnace: The aluminum melting furnace can't clean the slag when it is stopped. It is time-consuming and laborious. Because after the aluminum furnace has been used for a period of time, there is a lot of carbon deposition on the inner wall of the furnace. For example, more and more carbon deposits are not regularly cleaned, the volume in the furnace is getting smaller and smaller, and the carbon deposition is very hard. If the carbon deposition after the furnace is stopped, it can't be cleaned out. Let's talk about how to deal with it.
Method: Use a 3 meter diameter 30-40 round steel head to make a tip, and the other end is made like a chisel. After the tool is done, look for a day of normal production. After the melting furnace is fully liquefied, put it in the melting furnace. The molten aluminum is let go and added to the side of the furnace, and with good tools, it will hit the place where there is carbon deposition in the furnace from the slag hole, and the carbon will fall off one by one. 1-2 hours can be cleaned up. Of course, if there is only a little bit of waste inside, then only need to remove the material, the more, the next time the warming up of the road will melt away, in the normal production process, the furnace slag removal, one or two times a day can. Keeping this frequency lowers the failure rate, ensures the personal safety of workers, and improves the service life of the melting furnace is no longer a problem.
Hexagon Textured Glass Mosaic Tile
C&K MOSAIC , https://www.cnkmosaics.com