Basic knowledge of tile paving and paving acceptance

There are two ways to paving the floor tiles

Dry shop method: In theory, floor tiles should adopt dry shop method. After the base water is wetted, floating sand and debris are removed. Wipe the combination layer, use one to three dry cement mortar, paving according to the horizontal line, place the brick on the mortar and use a rubber-coated hammer to shake, remove the floor tile and pour the cement slurry, and then place the floor tile.

Wet shop method: The difference between this method and dry shop method is to replace one to three dry cement mortars with ordinary water and cement mortar.

Wall tile shop

Wall cleaning treatment - plastering ash - choose the tile-brick soaking - bricks - line - paste standard points - paste tile - jointing - Sew - post-cleaning should be checked before use Whether the color number and size are the ones you ordered, and whether the tiles of the same color have defects such as chromatic aberration or broken wire. Only use the same color number to make the color uniform.

Tile new trend

Dry stick method: tile adhesive is a new type of paving accessories. Tiles do not need to be pre-soaked, as long as the paving conditions are good, the bonding effect greatly exceeds the traditional mortar cement. Suitable for smaller projects and home renovations.

Colorful caulking agent: Generally used for the floor or wall surface of joints, which is characterized by good color adhesion, pressure resistance, abrasion resistance, non-alkalization, and non-shrinkage. It not only changes the problem of loose water in the tile gap, but also causes poor adhesion. Make the color of the crevices and tiles better.

New trend of the waistline: Compared with the horizontal waistline, the vertical waistline is even smoother on the line, and saves material. In the selection of the pattern, it is elegant, and the waistline with a cultural taste and modernity is resistant to seeing. Your other collocation choice.

Tile shop acceptance note:

The tiles must be firm and free of defects such as chamfered edges and cracks, and the surface should be flat, with clean and harmonious color. The brick joints should be densely packed, straight, uniform, and uniform in color.

Non-complete bricks are properly used and arranged straight.

The hole has the correct size and the edges are neat.

When checking the flatness, the error is less than 2mm, and the vertical error of the facade is less than 2mm.

Entrance decoration floor tile cement home improvement floor tile

Aluminum Alloy Handle

Aluminum Alloy Handle,Aluminum Alloy Door Handle,Hardware Wire Drawing Handle,Interior Door Handle

Guangzhou Junpai Hardware Co., Ltd , https://www.junpaihardware.com